Is standard commercial lightning risk assessment methodology applicable to a refinery?

The IEC 62305-2 methodology applies, but the consequence-of-loss factors used in the calculation must reflect explosion/fire severity, not just financial cost â this changes the recommended protection level, often requiring a higher LPL class.

Do fuel storage tanks need both static and lightning bonding, or is one sufficient?

Both are typically required â static bonding addresses electrostatic buildup during operations, lightning bonding addresses direct/indirect strike current; they're related but not interchangeable.

Can standard SPDs be used in a hazardous-area zone?

No â SPDs in classified hazardous areas need the correct zone/division rating (intrinsically safe or appropriately certified); using standard-rated equipment in a classified zone is a compliance and safety issue.

Lightning Protection for Oil, Gas & Hazardous Facilities

Refineries, LNG terminals, pipelines and fuel storage sites carry the highest consequence-of-failure profile in industrial lightning protection — a strike-induced ignition isn't just downtime, it's a safety event. LPES designs to hazardous-area requirements, not standard commercial specs.

Get Started Now

Lightning, surge and earthing protection for mission-critical industrial infrastructure. Designed, assembled and tested in-house by LPES International.

Phone: 08043888915

Email: info@lpesinternational.com

Say Hello To Us

Corporate Address – Asia

ILD Trade Centre, 6th Floor, Office No. 617
Sector-48, Gurugram – 122018, Haryana
Near Subhash Chowk

Corporate Address – Europe

1119 Budapest,
Csurgoi ut 22-32A,
37 Hungary, Europe

GSTIN: 06AAICR2536D2ZL | CIN: U74999HR2017PTC068669

Items have been added to cart.

One or more items could not be added to cart due to certain restrictions.

View Cart

Added to cart

- Can't add this product to the cart now. Please try again later.

Quantity updated

- An error occurred. Please try again later.

Deleted from cart

- An error occurred. Please try again later.

JavaScript is disabled in your browser. Please enable JavaScript to continue.