Almost before we knew it, we had left the ground. All their equipment and instruments are alive.Mist enveloped the ship three hours out from port. The spectacle before us was indeed sublime.A red flair silhouetted the jagged edge of a wing.
Lightning, surge and earthing protection for mission-critical industrial infrastructure. Designed, assembled and tested in-house by LPES International.
Phone: 08043888915
Email: info@lpesinternational.com
ILD Trade Centre, 6th Floor, Office No. 617
Sector-48, Gurugram – 122018, Haryana
Near Subhash Chowk
1119 Budapest,
Csurgoi ut 22-32A,
37 Hungary, Europe
GSTIN: 06AAICR2536D2ZL | CIN: U74999HR2017PTC068669
© Copyright 2026 @ LPES Company. All Rights Reserved.
LPES engineers assess the risk, design the system, install it, test it and keep it compliant — lightning protection, earthing and surge protection under one accountable team, to IEC 62305, IS 3043, IEEE 80 and the CEA Safety Regulations 2023.
Four pillars. One engineering responsibility, from Lightning to Load.
Each service states its scope, deliverables, standard and turnaround — and ends with a documented result in the LPES Protection Passport.
Findings with clause references, photographs, measured values and a prioritised action list.
Calibrated instruments and a signed test report for every point measured.
Calculations shown, drawings to your geometry, BOQs with part codes.
We install what we design and stay accountable with inspections at the IEC interval.
The tools LPES engineers use, available to designers, consultants and site teams.
Most failures are installation and inspection failures. Training closes the gap.
Follow a project from first question to lifetime assurance — and see which LPES service delivers each step.
Site survey, soil resistivity and an IEC 62305-2 risk assessment decide whether protection is needed and at what level — before money is spent.
Air-termination, down conductors, earthing and SPD zones drawn to your geometry, with the calculations shown.
A part-coded BOQ and approval dossier so the tender is priced on the same design that was approved.
LPES lightning protection, earthing and surge protection products — type-tested and traceable to their datasheets.
Installation by trained teams to the approved drawings, with exothermic joints, bonding and test joints where the design puts them.
Earth resistance, continuity, bonding and SPD checks recorded point by point before handover.
AMC inspections at the IEC 62305-3 interval, post-strike call-outs and one record — the LPES Protection Passport.
Risk-based design, CEA compliance and records an inspector accepts.
ConsultantsCalculations, clause references and editable drawings.
EPC contractorsMeasured BOQs, datasheets and on-time supply and installation.
OEMs & panel buildersSPD selection and LPZ coordination built into your panels.
No. Audits, testing, risk assessments and design reviews are independent of who supplied the products. Where we design and supply, the BOQ carries LPES part codes so the design and the hardware stay matched.
IEC 62305 parts 1–4 for lightning protection, IS 3043 and IEEE 80 for earthing, IEC 61643 for surge protective devices, IS 732 for wiring, and the CEA (Measures relating to Safety and Electric Supply) Regulations 2023 in India — plus your project specification.
Yes. LPES serves projects across India, the Middle East, Africa and Europe from Gurugram and Budapest, with designs and reports in English to IEC standards.
A short call or a few photos is enough to start. An LPES engineer replies with the next step.